XC23/XC33/XDL23/XDL33/XDL33D
 |
|
XC23/XC33/XDL23/XDL33/XDL33D |
|
Status Codes: (Press ‘0’ to see the sub code)
|
A Codes |
Document Feed Problems |
|
C Codes |
Paper Feed or Pre-registration Jam Problems |
|
E Codes |
Post-registration / Exit Jams & Duplex Problems |
|
F Codes |
Sorter Jam or Interlock Problems |
|
H Codes |
HCF (High Capacity Feeder) or ADF Problems |
|
J1 Code |
Toner Empty |
|
J3 Code |
Copy Cartridge not installed (or not seated properly) |
|
J7 Code |
Copy Ctg. count expired (replace the connector, See p.13) |
|
J8 Codes |
Improper Copy Cartridge (or not seated properly, See p.13) |
|
L6 Code |
Key Counter not installed |
|
L8 Code |
Platen Temperature too high |
|
L9 Code |
Communication error with Inter-Image Lamp PWB |
|
U1-1 Code |
Xerographic Motor Problem |
|
U2 Codes |
Scanner Drive Problems |
|
U3-1 Code |
Lens Drive Problem |
|
U4-1 Code |
Fuser Thermistor Open |
|
U4-2 Code |
Fuser took too long to warm up |
|
U4-3 Code |
Fuser stays on after reaching operating temperature |
|
U4-4 Code |
Fuser stays on too long after copy cycle |
|
U4-6 Code |
Fuser Over-temperature |
|
U5 Codes |
Sorter Bin Drive Problem |
|
U6 Codes |
Memory Problems / Main Board Problems |
|
U8 Codes |
Exposure Problems |
Diagnostics: Hold the ‘0’ while turning on the power to enter diagnostics. To enter a code, enter the 1st part of code, followed by ‘Print’, then the 2nd part of code & then ‘Print’ again.
Fuser Overheat Reset: (50-20): First make sure that you have repaired the cause of the overheat. Enter the diagnostic code 50-20 as explained above, then press ‘0’ followed by ‘Print’. NOTE: Watch to make sure the lamp cycles off the way it should once the machine comes to ready.
Read Total Copy Count: (30-50)
Read Copy Cartridge Life Remaining: (30-91)
Light Copy Problems? (ask us for a fax… 1 page of good help)