Developer Seal Blade Kit (4 Mylar Blades For 604K24219, 604K24229, etc.) for Xerox® Dc250 Style

$24.00
PD#
DC250DSBK
For Repairing the Top covers of the following DV Units: 604K24210, 604K24214, 604K24215, 604K24216, 604K24217, 604K24218, 604K24219, 604K50040, 604K50041, 604K50042, 604K50043, 604K75870, 604K85120, 604K86360, 604K86560, 604K24220, 604K24224, 604K24225, 604K24226, 604K24227, 604K24228, 604K24229, 604K50030

For Xerox® models: (DocuColor) DC240, DC242, DC250, DC252, DC260, (WorkCentre) WC-7655, 7665, 7675, 7755, 7765, 7775, Color 550, 560, 570,C60, C70 Digital Color Press 700, 700i, 770 & Digital Press C75, J75

Developer Seal Blade Kit (4 mylar blades)

 

This is a set of 4 mylar blades for the top covers of the developer units.

DC250 Developer Seal Blade Location 1   DC250 Developer Seal Blade Location 2

  

Installation: Check the new mylar's position against the old mylar before you peel off the old mylar. Then remove the old mylar and clean the DV Unit top cover thoroughly with isopropyl alcohol to get all adhesive off of there. The new mylars have peel and stick backing. You will want to lay one end in place and then get it nice and straight and lower it into place. Do not stretch the mylar or the edge will be wavy and it won't work right.

 

* Important Note: When fitting the mylar on a Black Unit, first compare the width because the black unit's mylar is positioned differently... you will see that you have to overlap where the original mylar's adhered edge lined up, by about 1 mm. It will get torn off by the drum if you line the adhered edge like the original one.
 

Fits all of the following:
Black DV Units * -
604K24210, 604K24214, 604K24215, 604K24216, 604K24217, 604K24218, 604K24219, 604K50040, 604K50041, 604K50042, 604K50043, 604K75870, 604K85120, 604K86360, 604K86560

Color DV Units (cyan, magenta, or yellow) -
604K24220, 604K24224, 604K24225, 604K24226, 604K24227, 604K24228, 604K24229, 604K50030, 604K50031, 604K50032, 604K50033, 604K86350, 604K86550